Panasonic RF-2800 LBS Bedienungsanleitung Seite 5

_ POWER SUPPLY.
Your National Panasonic radio receiver RF-2800LBS/LBE
operates from either of two sources: AC household power,
or 6 "D" size dry batteries.
Battery Operation:
1) Open the battery compartment cover by depressing its two
latches and pulling it toward you, as shown in Fig.1.
2) Insert 6 '"'D" size (National UM-1 or equivalent) batteries
into the battery compartment, making sure that the polarities
are aligned correctly (Fig. 2). Place them in the order shown
in Fig. 2.
Earphone Storage Pocket
Sb EG
rr
Ii Th
Ue I
UT AT II
Fig.2
3) Replace the compartment cover.
Note: « Removing the battery numbered '6' in Fig. 2 first will
make it easier to remove the other batteries.
* TO operate on battery power, be sure to disconnect the
AC power cord from the AC Input Jack@ and household
AC power outlet.
To check the battery condition:
1) Turn the Radio On/Off Switch@ and Digital Dispiay Switch@
to ON.
2) Tune to a position between stations.
The Tuning/Battery Indicator@ will then show the battery
condition.
NORMAL
When the indicator points within the ''O'' range as
shown above, the batteries can still be used.
Fig.4
When the indicator points within the 'x' range as
shown above, replace all the batteries with new
ones.
AC Power Operation:
MH With model RF-2800LBS, first check the AC Voltage Selector®
to ascertain if your receiver is adjusted to your household AC
voltage. If not, readjust by rotating the selector@ with a screw-
driver.
Model RF-2800LBE is not provided with AC voltage selector,
and should be powered by 240 volts only.
M Connect the accessory AC power cord to the AC Input Jack@®
and your household AC electrical outlet.
On plugging the power cord into the AC Input Jack@, opera-
tion changes from battery to AC.
110-125 Volts 220-240 Volts
220-240V @ 220-240V @
110-%725V e 110-125V @
Fig. 5
Voltage Selector
IMPORTANT (for model RF-2800LBE)
The wires in this mains lead are coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the termi-
nals in your plug proceed as follows:
* The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
x The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
lf a 13-amp. (BS. 1363) plug is used, a 3-amp. fuse must be fitted,
or if any other type of plug is used, a 5-amp. fuse must be fitted
either in the plug or adaptor or at the distribution board.