Hama 10.0 Bedienungsanleitung Seite 40

Electrical connection
The electrical connections must be made according to the following
| GB | instructions in order to ensure safe and error-free operation:
m Before you connect the device, compare the connection data for
the power supply adapter (voltage and frequency) on the type pla-
te with that of your mains power supply. This data must match to
avoid damage to the device.
m Keep the cable away from hot surfaces and sharp edges.
m Make sure not to bend the cable or pull it too tightly.
Installation and connections
For continuous playback, the device can be placed on a flat surface.
% Set up the device at an angle. Remove the base from the trans-
port bracket and screw it into the base socket.
CAUTION
The device can be damaged if it tips over or falls down.
> Make sure that the device cannot tip over.
% Connect the connection cable to the socket on the device and
plug in the power supply adapter.
NOTE
> Only use the enclosed power supply adapter.
40
00095219man_en.indd 40 &
08.07.11 10:56