Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the EUROLITE LED TMH-5 starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the LED TMH-5 can be used without controller.
Disconnect the LED TMH-5 from the controller and call the internal program. Please refer to the instructions
under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices.
Control Board
The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
UP
MODE/ESC
DOWN
ENTER
25/30
The main menu is accessed by pressing the
Mode/Esc-button. Browse through the submenu by
pressing Up or Down. Press the Enter-button in order
to select the desired menu. You can change the
selection by pressing Up or Down. Confirm every
selection by pressing the Enter-button. You can leave
every mode by pressing the Mode/Esc-button. The
functions provided are described in the following
sections.
00048779.DOC, Version 1.1
Werbung
