Sharp VC-A605G Serviceanleitung Seite 6

VC-AGO5S(BK}
VC:A505S{(BK}
: Remarks
ne hee]
| These Jigs are used for checking and
adjusting the reel disk height.
This Jig is used for settimg the A/C
head tilt.
A/C Head Tilt Adjusting Jig
These Jigs are used for checking and
4 adjusting the torque of take-up and
supply ree! disks.
This cassette torque meter is used
for checking and adjusting the
torque of take-up and supply reel
and for measuring tape back
tension.
Cassette Torque Meter JiGVHT-063 .
There aré two Gauges used for the
tension measurements, 300 g and
2.0 kg.
Tension Gauge (300g). . _. JiGSGO300.
Tension Gauge (2.0 kg) -. JigsG2000°
These Jigs are used for loosening or
tightening special Hexagon type
screws.
Hex Wrench (1.2 mm} JiGHWO012 lp
This tape'is especially used for
electrical fine adjustment.
Alignment Tape (PAL) VROCPSV . ai
a)
This is used for replacement of the
VCR's upper drum.
wee
Drum Replacing Jig r JiGDT-0001 tg
This Jig is eed for the tension
gauge. Rotary Transformer
Clearance Adjusting Jig.