Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTE
• A newly installed filter may cause the water dispenser to spurt water briefly. This is
because air has entered the waterline.
• The replacement process may cause the water dispenser to drip for a short period of
time. If it drips, simply wipe up any water on the floor with a dry towel.
Reverse osmosis water filtration system
The water pressure of the water supply system to a reverse osmosis water filtration
system must be between 206-861 kPa.
The water pressure of the reverse osmosis water filtration system to the refrigerator's cold
water line must be at least 206 kPa. If the water pressure is below these specifications:
• Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter
if necessary.
• Refill the water tank in the reverse osmosis system with water.
• If your refrigerator has a water filter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water filter.
For more information or servicing, contact a licensed plumbing professional.
Ordering a new filter
To purchase a new water filter, contact a local Samsung service center.
Untitled-1 75
6. Turn the cartridge knob clockwise to
lock into place.
7. Close the filter cartridge cover.
8. Reset the water filter replacement
alarm. (For detailed instructions, see the
"Resetting or dismissing the water filter
replacement alarm (applicable models
only)" section on page 56.)
English
75
2023-08-29
11:11:04
Werbung
