Panasonic CF-VEB271 Bedienungsanleitung Seite 6

H
Connecting/Disconnecting
VA Slide the lever to connect to the expansion bus
connector of the port replicator.
(CAUTION )
® Do not attempt to make connections if there is any object between the computer and the port
replicator. Doing so could damage the computer and the port replicator.
O Do not attempt to move the port replicator when it is connected to the computer.
O If the computer malfunctions while the port replicator is attached, refer first to the "Trouble-
shooting" section of the computer's "Operating Instructions". If you still are unable to solve the
problem, power off the computer, disconnect the port replicator, connect the AC adapter to the
computer, and check to see if the computer operates normally. If the computer operates nor-
mally when the port replicator is not attached, the port replicator may be malfunctioning. Please
contact Panasonic Technical Support.
Disconnecting
1 Power the computer off.
Slide the lever to disconnect to the expansion
bus connector of the port replicator.
3 Lift the rear corners first, then release the front
corners.
Close the cover of the expansion bus connector
Ge
SE
of the computer. = N
Cover ofthe Expansion Bus Connector