Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting/Disconnecting
Do not connect or disconnect the port replicator while the computer is powered on.
Connecting
1 Power off the computer, and disconnect all cables from the computer.
Connect the plug of the AC adapter that came with
O
the computer to the DC-IN jack of the port replicator
©
©
W
and plug the other end into an AC outlet.
|
GEKKO
O Be sure to use the AC adapter. (The port replicator will not function using the computer's
battery power.)
O Do not use other than the specified AC adapter (Model No.: CF-AA1639) and AC cord.
O Refer to the "Operating Instructions" that came with the computer for information on proper
handling of the AC adapter and AC cord.
an
3 Close the cover of the back side of the computer
E
and the cover of the DC-IN jack firmiy.
S=
Cover of the back side
Cover of the DC-IN jack
N
4 Open the cover of the expansion bus connector of the
s
computer.
Cover of the Expansion Bus Connector
5 Confirm that the security lock is unlocked, move the
lever to the right side to the end.
x
=
6 After confirming that the expansion bus connector of
the port replicator is positioned so that the computer
can be docked, insert the front corners of the computer
and then press down lightly on the rear corners onto
the port replicator guide pins.
Werbung
