Laspaziale MAC 65 Bedienungsanleitung Seite 19

PRESSING
Spring device
Position the filter holder into the fork with the
pressing disc, and then press the knob down-
wards .
WARNINGS FOR OPERATION
· For coffee grinder-dosers, the doser lever
must always be pulled down as far as pos-
sible: never pull it only partly .
· For coffee grinders, make sure that the cof-
fee outlet is free from any obstruction oth-
erwise the appliance will stop . To empty out
all the ground coffee, firmly pull the outlet
handle . Use adequately sized bags to collect
the ground coffee so that the entire amount
of coffee coming out can be collected .
SAFETY DEVICES
Thermal overload protection
The grinder-doser motor is protected against
overheating resulting from overcurrents by
a thermal overload protection which, when
tripped, cuts off the power supply to the mo-
tor . If the thermal protection device should au-
tomatically turn on in the event of anomalous
operation (such as the grinding blades jam-
ming), turn off grinder-doser using the On-Off
switch, unplug it from the mains, and contact
skilled technical personnel . Never perform any
work on the grinder-doser while it is attached
to the mains, in order to prevent the motor
from turning on suddenly . If the grinder-doser
overheats as a result of the motor stopping,
allow the grinder-doser to cool down before
performing any repair work .
Adjustment disk lock
In order to prevent the adjustment disk from
being removed, which would make the rotating
parts accessible, there is an anti-unscrewing
adjustment disk lock (safe) positioned under
the adjustment disk .
Coffee outlet guard
The coffee outlet guard must always be fixed to
the doser unit using the relevant screws, which
must never be removed by the user . The re-
moval of the coffee outlet guard can be done
by skilled technical personnel only after dis-
connecting the grinder-doser from the power
supply by unplugging . Before reconnecting the
grinder-doser to the power supply, replace the
safety device .
NOISE LEVEL
EEC Countries - The maximum noise emission
of our coffee grinders and grinders/dosers
measured in UNI EN ISO 3741 reverberating
chamber in compliance with the EN 60704-1
regulations, is compliant with the EN 60704-1
: 1998 and EN 607043 : 1996 regulations . The
sound pressure level emitted by the equipment
is <70 dB in compliance with EN 60704-2-11
(EN ISO 11201 and ISO 3744) . Therefore, when
operating the appliance, no provisions need to
be taken in order to prevent such risks arising
from noise exposure in the workplace (articles
3-8 of ED 2003/10/EEC) .
MAINTENANCE
It is essential to periodically check the state
of the supply cable and plug . In the event
the supply cable or plug are damaged, call in
skilled technical personnel to replace them,
in order to prevent any risk . In CE-certified
appliances a special tool is required to open
the base plate to access the cable . We rec-
ommend using original spare parts only . In
19