Laserworld Club Serie Bedienungsanleitung Seite 9

Manual: CS-2000RGB FX MK3 | CS-4000RGB FX MK2
4.1. SOUND-TO-LIGHT
Sound-to-light operation allows to playback the integrated patterns to the beat of music or
any noises.
Select „SoUd" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard selection is „ALL", which means that all patterns saved on the main board are played
back. You can decide to use only a certain part of the pattern set with a certain grating by
selecting ALL (for all the gratings), L001, L002, L003, L004, or no grating with L005:
To set the sensitivity of the internal microphone, refer to chapter „4.5. Settings"
4.2. STAND-ALONE / AUTO
Stand-alone or Auto operation allows to random playback the internal patterns.
They are played back according to the internal system settings.
Select „AUto" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard selection is „All", which means that all patterns saved on the main board are played
back. You can decide to use only a certain part of the pattern set with a certain grating by
selecting ALL (for all the gratings), L001, L002, L003, L004, or no grating with L005:
4.3. MASTER-SLAVE
This laser is Master-Slave capable. This means that the Master laser system can hand on a con-
trol signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product genera-
tion.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cables. Make
sure to use the „DMX out" port on the Master and the „DMX in" on the Slave lasers. If several
Slave lasers are used, link the first one to the Master laser and daisy-chain the control signal
from the first Slave laser to the second etc..
B: Activate Master Laser
The Master laser needs to be set as control source.
Select „SEt" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
English
page 9 / 37