Laserworld Club Serie Bedienungsanleitung Seite 13

Microphone Sensitivity Settings
The sensitivity of the built-in microphone for the control of the sound-to-light operation can
be adjusted in the „SEnS" menu. Press „Enter" to change the settings. Use the „Up" / „Down"
button to change the selection.
The sensitivity can be adjusted between 1 and 100. Standard value is 50.
4.6. ILDA / COMPUTER CONTROL
The laser can be used with any laser control software that supports the ILDA control signal
via sub-d connector. Use an ILDA cable to connect the Digital Analog Converter (DAC / ILDA
interface) of the laser software to the ILDA in port at the laser.
To operate the laser in ILDA mode the „ILdA" menu must be selected. Press „Enter" to change
the settings.
Grating Effects Settings in ILDA mode - DMX grating control on ILDA
Once ILDA mode is selected, the standard selection is „L001", which means that the laser will
automatically switch through the grating effects. A certain grating effect can be selected
with L002, L003, L004. If L005 is selected there is no grating effect.
Use the „Up" / „Down" button to change the selection:
For DMX control of grating effects while on ILDA:
• set a DMX address as specified in „4.4 DMX 512" section
• select „d512" in the backpanel and press Enter
• on the DMX control you have to turn channel 1 to 255, channel 15 to 1-199 and then
you can control the Grating wheel with channel 14.
English
Manual: CS-2000RGB FX MK3 | CS-4000RGB FX MK2
page 13 / 37