Laserworld Club Serie Bedienungsanleitung Seite 8

Manual: CS-2000RGB FX MK3 | CS-4000RGB FX MK2
• Clean the exit window with glass cleaner
from time to time
Removal of the warranty label as well
•
6. General Operation
1. Power
Connect the power cord to the device and to the mains.
vided with the correct voltage. Wrong voltage could lead to irreparable damages. Please
find the correct voltage data in the synoptical table at the end of this manual. Make sure
that the device is not directed to people or inflammable objects during installation. To
start the device, connect the interlock bridge, insert the key and switch it on, and switch
the device on. The "Emission - Laser on" LED at the front side of the device begins to
light up when the device is ready for use.
2. Key Switch
There is a key switch at the back of the laser system. Please plug the key to the switch and
turn it on. The laser device only runs when the key is inserted and switched on. Prevent
misuse! Unplug the key when the laser is unattended to prevent misuse of the sys-
tem.
3. Fuse
There is a fuse at the back side of the device. If the fuse should blow, please exchange
it with a new one. If the problems recurs, please contact your dealer or the Laserworld
service department.
4. Modes / Functions
The different operation modes can be selected via the four buttons next to the „Set-
tings" display.
„Enter" confirms a selection or navigates to the selected menu item.
„Up" / „Down" allows for stepping through the current menu or to make a selection.
„Exit" exits the current menu item and moves one level higher.
page 8 / 37
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
Make sure that your device is pro-
English