Laserworld Club Serie Bedienungsanleitung Seite 10

Manual: CS-2000RGB FX MK3 | CS-4000RGB FX MK2
Use the „Up" / „Down" buttons to navigate to „uASt"
Press „Enter", use the „Up" / „Down" buttons to switch the option to „on" and confirm with
„Enter"
C: Deactivate Master setting on Slave lasers
As soon as the Master option is set to „on", the laser sends out the control signal for the Slave
units. Make sure that all Slave units have the Master setting set to „oFF":
D: Set Sound-to-Light or Auto mode on Master laser
To use the Master-Slave operation: set the Master to either Sound-to-Light mode (4.1) or
Auto mode (4.2.).
E: Establish link to Slave lasers
The Slave units must be set to DMX („d512") mode and must be assigned address 001 (see
4.4. DMX 512)
4.4. DMX 512
The DMX mode requires a DMX controller or a Master laser (see 4.3. Master-Slave operation)
to be connected to the laser.
To switch to DMX mode, select „d512" by navigating with the „Up" / „Down" buttons and
confirm with „Enter":
The submenu for setting the DMX address loads:
Press „Enter" and the „Up" / „Down" buttons to set the desired DMX address.
Confirm with „Enter" and press „Exit" to return to the main menu.
English
page 10 / 37