Herunterladen Diese Seite drucken

HIKMICRO AI Serie Schnellstartanleitung Seite 69

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
return this product to your local supplier upon the
purchase of equivalent new equipment, or dispose of it
at designated collection points. For more information
see: www.recyclethis.info
Directive 2006/66/EC and its amendment
2013/56/EU (Battery Directive): This product
contains a battery that cannot be disposed
of as unsorted municipal waste in the
European Union. See the product documentation for
specific battery information. The battery is marked with
this symbol, which may include lettering to indicate
cadmium (Cd), lead (Pb), or mercury (Hg). For proper
recycling, return the battery to your supplier or to a
designated collection point. For more information see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-003 (A) / NMB-003 (A)
standards requirements.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled environment.
For this device, please pay attention to the following notes
when the device is operating in 5 GHz:
(i) The device for operation in the band 5150-5250 MHz is
only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) The maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz shall
comply with the e.i.r.p. limit; and
(iii) The maximum antenna gain permitted for devices in
the band 5725-5825 MHz shall comply with the e.i.r.p.
limits specified for point-to-point and non point-to-point
operation as appropriate.
Users should also be advised that high-power radars are
allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN
devices.
Conformité Industrie Canada ICES-003
Cet appareil répond aux exigences des normes CAN
ICES-003 (A)/NMB-003 (A).
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radioexempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
ce matériel est conforme aux limites de dose d'exposition
aux rayonnements, CNR-102 énoncée dans un autre
environnement.
(i)Les dispositifs fonctionnant dans la bande 5150-5250
MHz sont réservés uniquement pour une utilisation à
l'intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles utilisant
les mêmes canaux.
(ii) Le gain d'antenne maximal autorisé pour les appareils
dans les bandes 5250-5350 MHz et 5470-5725 MHz
doivent respecter le pire limiter; et
(iii) Le gain d'antenne maximal autorisé pour les appareils
dans la bande 5725-5825 MHz doivent respecter le pire
limites spécifiées pour le point-à -point et l'exploitation non
point à point, le cas échéant.
Les utilisateurs de radars de haute puissance sont
désignés utilisateurs principaux (c.-à -d., qu'ils ont la
priorité) pour les bandes 5250-5350 MHz et 5650-5850
MHz et que ces radars pourraient causer du brouillage
et/ou des dommages aux dispositifs LAN-EL.
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property loss.
Laws and Regulations
● Use of the product must be in strict compliance with
the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while
transporting it.
● Keep all wrappers after unpacking them for future use.
In case of any failure occurred, you need to return the
device to the factory with the original wrapper.
Transportation without the original wrapper may result
in damage on the device and the company shall not
take any responsibilities.
● Do not drop the product or subject it to physical shock.
Keep the device away from magnetic interference.
Power Supply
● Please purchase the charger by yourself. Input voltage
should meet the Limited Power Source (5 VDC, 2 A)
according to the IEC61010-1 standard. Please refer to
technical specifications for detailed information.
● Make sure the plug is properly connected to the power
socket.
● DO NOT connect multiple devices to one power adapter,
to avoid over-heating or fire hazards caused by
overload.
Battery
● CAUTION: Risk of explosion if the battery is replaced by
an incorrect type. Replace with the same or equivalent
type only. Dispose of used batteries in conformance
with the instructions provided by the battery
manufacturer.
● Improper replacement of the battery with an incorrect
type may defeat a safeguard (for example, in the case
of some lithium battery types).
● Do not dispose of the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may result
in an explosion.
● Do not leave the battery in an extremely high
temperature surrounding environment, which may
result in an explosion or the leakage of flammable liquid
or gas.
● Do not subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of
67

Werbung

loading