Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROTECTION CIRCUIT
The Operation-LED (POWER, fig. 1,1) lits up, if the amplifier is in operation.
The protection LED (PROTECT, fig. 1,1) lits up, when the amplifier is overheated, or a short circuit occurs
resp. a too low impedance load is connected to the speaker outputs. If this events, the internal built-in protec-
tion circuit shuts down the amplifier automatically. The amplifier should work again properly after you have
solved the problems.
FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
PROTECT-LED and POWER-LED
(2)
Connector for the included bass level remote controller
(3)
BASS EQ controller
(4)
Low Pass / Band Pass filter controller
(5)
Selector LPF/BPF (Low Pass/Band Pass) / FULL (Full Range) / HPF (Subsonic/High Pass)
(6)
Sub Sonic / High Pass filter controller
(7)
Gain level controller
(8)
Audio signal inputs
(9)
Audio signal outputs for additional amplifiers
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Vehicle's battery
(5)
In-Line Fuse (not included in the scope of delivery)
(6)
Turn on wire from the head unit or the electrical antenna
(7)
Fuse(s)
1-CHANNEL OPERATION MONO 1 SUBWOOFER (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer (2 - 8 Ω)
1-CHANNEL OPERATION MONO 2 SUBWOOFERS (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive two subwoofers, con-
nect the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer 1 (4 - 8 Ω)
(5) Subwoofer 2 (4 - 8 Ω)
IMPORTANT!
Always observe the correct polarity of all connections!
11
Werbung
