The Reset Button - Netro SPRITE Schnellstartanleitung

The LED Light
The ED light on your Sprite has three possible statuses:
Blinking slowly
is in Its HOST mode
it, and indicates that it needs to go through the setup steps in the app to
connect to a home
Solid: this means the unit is connected
Blinking quickly
when you first set up your unit and did not enter the correct password,
whenever it loses
The Reset
The reset button is located underneath the cover and is next to the AC adapter
wiring slots It is marked RST You wi need a pin or long, thin object to press
the button
Short press: to reset your Sprite to its HOST mode, simply press the button
once for less than 1 second
seconds
Long press: to reset the unit to factory settings, hold down on the button for
6-8 seconds. Wait for 1-2 minutes, the ight on your Sprite should start blinking
slowly
(on for a second and off for a second): this means the unit
This happens when you first plug in your Sprite or reset
WiFi network
(on for 0 5 second and off for 0 5 second): This happens
Its connection to the
Button
Your Sprite shou d start blinking slowly in a few
to your home WiFi
Netro cloud server
or