Netro SPRITE Schnellstartanleitung Seite 11

Troubleshooting
During the Wi-Fi setup, my home Wi-Fi cannot
Please make sure your router is turned on and has a signal of at least 2 bars
on your phone at the location where your device is installed Sprite only connects
to 2 4 GHz Wi-Fi networks
The app says Sprite is watering
Please check the wires Are they oose or disconnected
also check the common wires and the master valve if you have one. f you
believe the wires are correctly installed, you might want to check whether
there are shorted zones or open zones You just need to use a multimeter to
measure the resistance
reading would be 20-60 Ohms
might have a shorted circuit in the solenoid and if it is arger than 80 Ohms you
might have an open circuit
The light on Sprite is blinking
If your app shows the device is offline, your Sprite is unable to connect to
your home WiFi (possible causes: 1. your router is down; 2 Wi-Fi signal is
weak; 3 the SSID/password is changed) or the router has no access to the
internet. f your app shows the device is online, you do not need to do anything
There was a network glitch when the device tried to get the watering schedules
from the cloud server The light will be back to steady when it updates the
schedules successfully
power) if it does not
You might also try to reboot your router
between the common
If the reading is ess than 10 Ohms then you
fast (twice per second).
in an hour. Reboot your sprite (unplug and rep ug the
but it is not opening
from the slots? Please
wire and each zone
be discovered.
the valves.
The normal
9