Netro SPRITE Schnellstartanleitung Seite 4

Preparation
O Testthefunctionality o f yourirrigation systemwithyour
current controller first. If it does not work, please make
sure it is repaired before installing the Sprite.
Note: If you are not sure about the condition of your sprinkler system, you might
want to check whether there are shorted zones or open zones. You just need to
use a multimeter
zone. The normal reading would be 20-60 Ohms. If the reading is less than 10
Ohms then you might have a shorted circuit in the solenoid and if it is arger than
80 Ohms you might
I professionalsfor additional support.
Unplug the power of your current controller.
O Takea photoofthewiringin yourold
controller. When you are wiring Sprite,
this photo can be the reference
Remove your current controller.
to measure the resistance
have an open
between the common
circuit Please contact
wire and each
us or irrigation
-2