Werbung
V@AS7SMIGY)
VEINS7¥MIGY)
oe
-
"ADJUSTMENT, REPLACEMENT AND ASSEMBLY |
OF MECHANICAL UNITS
Here we will describe a relatively simple service
We are sure that the easy-to-handle tools listed
work in the field, not referring to the more
below would be more than handy for periodical
complicated repairs which would require the use of ©
maintenance to keep the machine in its original
special
equipment
and tools (drum
assembly
working condition.
replacement, for example).
TOOLS NECESSARY FOR ADJUSTING THE-MECHANICAL UNITS
The following tools are dea for proper service and satisfactory repair.
Ce
'y
Reel Disk Height Adjusting Jig
~
a=
Master Plane Jig
JiGRHG002
These Jigs are used for eclnas and
_ | adjusting the réel disk height -
recone: " 1
BY
|
This Jig is used for setting the A/C
A/C Head "ini aaiastingiie'
BU
Torque Gauge (90g)
) -4iGTE0090 :
Torque Gauge (1.2 kg)
JiGTG1200
9
s
These Jigs are used for checking and
adjusting the torque of take-up and
supply reel disks.
This cassette torque meter is used
for checking and adjusting the
torque of take-up for measuring
tape back tension.
JiGVHT-063
Cassette Torque Meter
Tension Gauge (300g)
Hex Wrench (1.2mm)
-
eae
———
| There are two gauges used for the
tension measurements, 300 g and
2.0 kg.
Tension Gauge (2.0kg)
These Jigs are used for loosening or
tightening special hexagon type
Screws.
This tape is especially used for
electrical fine adjustment.
Alignment Tape PALAU Lp)
_ VROUBZFS
Drum ReplacingJig
.
«; . | JIGDT-0001
This is used for replacement of the
~~] VCR's upper drum.
7)
NI
Werbung
