Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING |
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this compo-
nent, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and elec-
trical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PLONEER authorized service center
or your dealer to carry out repair work.
Symptom
Probable Cause
Power not furnished
¢ Power plug is disconnected.
Remedy
¢ Connect power plug securely to wall outlet.
to the unit.
© If power plug is connected to the auxiliary
¢ Turn on power to other component.
outlet of another component, power is not be-
ing supplied to that component.
No sound.
* Connecting cords are disconnected from their
[When playing
tapes]:
[In other cases]:
terminals, or connected improperly.
©
¢ Terminals or connecting cord pin-plugs are dir-
ty.
e The ADAPTOR switch is not in the correct
position.
© The MUTING switch is ON.
© Incorrect tape deck operation.
© The input selector switch is not set to the
playback component.
¢ Incorrect operation of other components.
© Fasten connecting cords correctly and secure-
ly.
,
(CEC
bas
¢ Clean terminals and pin-plugs.
2—r—
@ When using an adaptor device, turn this switch
ON; when not using an adaptor device, turn it
OFF.
¢ Turn the switch OFF (MUTING indicator will
go out).
® Consuit the operating instructions for your tape
deck.
© Set switch correctly.
© Consult the operating instructions for your
other components.
No sound from one
speaker.
© Connecting cords or speaker cords are discon-
nected on one side.
© The balance control is set too far to one side.
* Connect cords securely.
© Set the control in the center position.
Cannot record audio
tapes.
© Incorrect tape deck operation.
Cannot perform tape
copying.
e Incorrect tape deck operation.
¢ Consult the operating instructions for your tape
deck.
© Consult the operating instructions for your tape
deck.
<ARE1026>
1
Werbung
