Pioneer C-90 Bedienungsanleitung

STEREO CONTROL AMPLIFIER
STEREO-STEUERVERSTARKER
S s
i s
AMPLIFICATEUR DE CONTROLE STEREO
AMPLIFICATORE DI CONTROLLO STEREO
Cc-90
Mode d'emploi
Istruzioni per uso
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex-
planatory drawings. However, the method of connecting and
operating the unit is the same.
WARNING: To prevENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
{For U.S. and Canadian models]
[For Canadian model]
CAUTION: to prevENT ELECTRIC SHOCK DO NOT
—
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
Medium-size screwdriver
a)
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
a SPs xv oe
=<
ATTENTION:
pour prevenir Les CHOCS ELEC-
Set the voltage selector switch for the voltage in your area.
[ium]
TRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC
Pd
UN PROLONGATEUR
UNE PRISE
DE COURANT OU UNE
ap
_
AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT
ey
ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE
A DECOUVERT.
L
110—120 V 220-240 V
CONTENTS
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
The line voltage selector switch is on the rear panel. Before
your model is shipped from the factory, this switch is set to
the power requirements of the destination. Check that it is set
properly before plugging the power cord into the AC outlet. If
the voltage is not properly set or if you move to an area where
the voltage requirements differ, adjust the selector switch as
follows.
1. Provide yourself with a medium-size screwdriver.
2. Insert the screwdriver into the arrow on the voltage selec-
tor, and adjust so that the tip of the arrow points to the
voltage value of your area.
Q PIONEER'