Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Press (
Alt
3
+CF~)
, then
CS")
to save the file. Then press
C
Alt
3
+©, then
cs
to
exit the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file,
edit autoexec.bat (
Enter)
7 Move the cursor to the line containing "MSCDEX.EXE'' and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
(_
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE/D:MSCDOOO/L:L
(If this line is missing, add it.)
8
Press (
Alt
) +
Q0
, then fS~) to save the file. Then press (
Alt
) +
then
00
to
exit the Edit program.
Restart the computer.
Power-saving mode
If the DVD-ROM Drive Pack has not been accessed within 120 seconds, the drive motor
will automatically shut down to reduce the power consumption. When the DVD-ROM
Drive Pack is accessed once again, the power of the drive motor is turned on. However,
approximately 30 seconds are required until data is actually read from the disc.
Xnote)--
• [3I/2 Floppy (A:)] displayed in [My Computer] can be selected, only when you use a
floppy disk drive as an external device (q=* page 6).
•References to "CD-ROM" in the Setup Utility will not change depending on the
computer when the DVD-ROM Drive Pack is installed.
• If the vibration of the DVD-ROM drive is excessive, set the CD-ROM/DVD-ROM
Drive Speed to [12x](or displayed [Low]) in Setup Utility. ( The display of the item
may remain unchanged depending on the computer when the DVD-ROM Drive Pack
is installed.)
Werbung
