Lennox SWING Bedienungsanleitung Seite 11

DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21 °C to 28°C.
3. Push the ON/OFF button, the operation lamp lights and the air conditioner start to
operate DRY. Push the ON/OFF button agair to stop it.
NOTE
In light of the difference of the setting temperature and indoor temperature, Air Conditioner
in DRY mode will automatically operate many times without running the COOL and FAN
mode.
TIMER Operation
PUSH TIMER button to set the TIMER on time and TIMER off time.
1. Only set the starting time.
1.1 Please push the CANCEL button to cancel the former settings if there is.
1.2 Push the TIMER button, then the remoce controller show the TIMER and the signal "h"
was shown on the display panel. It is ready to readjust the TIMER ON to start the
operation.
1.3 Push the TEMP button ( ▼ or ▲ ) to set desired time you want to start.
1.4 After finishing setting TIMER 0.5 second the remoce controIler will transmit the signal
to the air conditioner. then after 2 seconds the digital area will show the temperature
again.
2. Only set the stopping time.
2.1 Please press the CANCEL button to cancel the former settings if there is.
2.2 Push the TIMER button, then the remote controller shows the last setting of starting
operation TIME and the signal "h" was shown on the display panel. It is ready to
readjust the TIMER OFF to stop the operation.
2.3 Push the TEMP button to cancel the TIMER ON the digital area show "00".
2.4 Push the TIMER button and the remote controller show the las' setting time of stopping
the operation and the signal "h" will be shown on the display panel, it is ready to
readjust to set the time of stopping operation.
2.5 Push the TEMP button ( ▼ or ▲ ) to set the time you want to stop the operation.
2.6 After finishing setting TIMER 0.5 second, the Remoce Controller will transmit the signal
to the Air Conditioner. Then after 2 seconds, the Digital Area will show the number of
temperature again.
3. Set the starting & stopping time
3.1 Please push the CANCEL button to cancel the former settings if there is.
3.2 Push the TIMER button, then the remote controller show the last setting starting
operation TIME and the signal "h" was shown on the display panel it is ready to
readjust the TIMER ON to start the operation.
3.3 Push the TEMP button ( ▼ or ▲ ) to set the time you want to start the operation.
3.4 Push the TIMER button and the remote controller show the last setting time of stopping
the operation and the signal "h" will be shown on the display panel. It is ready to
readjust the Time of stopping operation.
3.5 Push the TEMP button ( ▼ or ▲ ) to set the time you want to stop the operation.
3.6 After finishing setting TIMER 0.5 second the remote controller will transmit the signal to
the air conditioner. then after 2 seconds the digital area will show the of temperature
again.
NOTE
1. Please reset the TIMER after canceling the former time settings.
2. The setting time is relative time that is the time you set is the delay of the current time.
8