Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
8.4.3
8200510 BA / EN
Operating Instructions Booster WA 121545
Press the "Set" button (Figure 11, Pos. 2) for longer than 3 seconds.
"
The LED of the newly set curve lights.
F
The newly set curve is saved.
F
Recommendations:
Y
C1: EURO6-Generator without input voltage sensor
F
C2: EURO6-Generator with input voltage sensor
F
C3: Medium loading of the starter battery circuit with input voltage
F
sensor
C4: Low loading of the starter battery circuit with input voltage sensor
F
Setting the maximum output current, "Max. Output"
Turn off the vehicle engine.
"
Keep pressing the "Display" (Disp.) button (Figure 11, Pos. 1) until the
"
LED above the "Max. Output" column lights.
The LED above the "Max. Output" column lights.
F
The LED of the maximum current currently set lights in the left-hand
F
column.
Within 6 seconds, press the "Set" button (Figure 11, Pos. 2) for longer
"
than 3 seconds.
The LED above the "Max. Output" column flashes.
F
The LED of the maximum current currently set flashes.
F
Keep pressing the "Set" button (Figure 11, Pos. 2) until the LED of the
"
maximum charge current required (45, 55, 63 or 70 A) flashes:
Press the "Set" button (Figure 11, Pos. 2) for longer than 3 seconds.
"
The LED of the newly set maximum current lights.
F
The newly set maximum current is saved.
F
DANGER!
Y
The fuse and cabling on the output side must be designed for the maxi-
mum charge current set. Otherwise the battery fuse will keep tripping or,
for too high a fuse rating and too low a cable cross section, a cable fire will
result (also refer to Section 7).
Date: 21.09.2017
21
Werbung
