Xetron LMG-10 X Benutzerhandbuch Seite 4

1.3 Key Function
Power Key
Mode
MODE
Backlight/Zero
ZERO
Start/Pause
Back/Forward
+
MODE
Combined Keys
+
MODE
+
ZERO
+ Combined Keys
ZERO
1.4 General Technical Data
Specification
Measuring Range
Switch on/of
1.Short press:Switch sub mode of PT interface/
Switch Settings of SET interface
2.Long press:Enter the SET interface
1.Short press: Turn backlight on/off
2.Long press: The data is cleared, and pressure
zeroing
Open/Close the pressure holding state of
HOLD interface
1.Switch the refrigerant type of PT interface
2.Switch sub-options of SET interface
Switch the three main modes of pressure
and temperature measurement, vacuum
measurement and pressure holding test
Note:The key should be pressed at the same time
Adjust screen backlight from bright to dark
Adjust screen backlight from dark to bright
Note:The key should be pressed at the same time
Pressure: -14.5~800psi、-1.01~56.24kg/cm
-0.1~ 5.5MPa、-1~55 bar
Temperature: -40~302℉/-40~150℃
2
Values
、-100~5515KPa、
2