Sthor 78155 Bedienungsanleitung Seite 9

PRODUCT OVERVIEW
The rechargeable glue gun is used for joining various materials using hot-melt glue sticks. With the powerful, high-capacity battery, it is possible to work with
the product wherever guns with an external power source are not practicable. The product is not designed for commercial use. Proper, reliable and safe
operation of the product requires its correct use, that is why you should:
Read this entire manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety regulations and recom-
mendations of this manual. Use of the tool for purposes other than those for which it was intended shall cause the loss of the user's rights to a warranty and
under statutory warranty.
PRODUCT ACCESSORIES
The tool is supplied complete. The battery and charging station are not included.
TECHNICAL DATA
Parameter
Part no.
Operating voltage
Rated power
Protection rating
Insulation class
Glue stick diameter
Operating temperature
Heating time
Weight
Battery type
SAFETY INSTRUCTIONS
Careless use of the equipment can cause fi re, therefore: be careful when using the equipment in areas with
combustible materials; do not use the equipment in the presence of an explosive atmosphere; be aware that
heat can be transferred to combustible materials out of sight; after using the equipment, place it on its stand and
allow it to cool down before storing it; do not leave switched on equipment unattended.
Before starting work, check whether the body of the housing and the battery are not damaged. If damage is
found, further work is prohibited. This equipment must not be used by children. Children should not play with
the equipment. Cleaning and maintenance of the equipment should not be performed by unsupervised children.
This equipment must not be used by people with reduced physical and mental capabilities and people with no
experience and knowledge of the equipment, unless supervision or instruction is provided on how to use the
equipment in a safe way so that the associated risks are understood.
The device is not designed to work in high humidity conditions. The temperature in the place of use of the device
must be in the range of +10 C ÷ +38 C, and the relative humidity must be below 70% without condensation.
O O
O R I G I N A L
EN
Unit
[V DC]
[W]
[mm]
[ O C]
[s]
[kg]
I N S T R U C T I O N S
Value
78155
20
25
IPX0
III
11
200
60
0.3
Li-Ion
9