Sthor 78155 Bedienungsanleitung Seite 11

EN
MAINTENANCE AND OVERHAUL
CAUTION! Before carrying out any adjustment, servicing or maintenance work, unplug the tool from the power outlet. Having fi nished working with the
workpiece/material, inspect the power tool for damage by visually inspecting the exterior and the body and the handles. Check the power cord and its rubber
gland, the action of the ON/OFF switch, the vents for clogging, the motor brushes for sparking, the noise of the bearings and the drive transmission, and how
the power tool starts and runs. During the warranty period, the user is not allowed to disassemble the tool or replace any components or parts, as this will
void the warranty rights. Any irregularities found during overhaul or the operation signal the need for repair at a service centre. For this purpose, contact the
manufacturer. Having fi nished your work, clean the housing, the vents, all switches, all handles and guards with compressed air (at 0.3 MPa maximum), a
brush or a dry cloth. Do not use any chemicals or cleaners. Do not use sharp tools for cleaning. Remove the circular saw and clean the inside of the guards,
the fi xing of the circular saw, as well as the saw itself from dust and other impurities generated during operation. Clean handles, knobs and other adjusting
parts with a dry, clean cloth.
11
O R I G I N A L I N S T R U C T I O N S