Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Contents
7.3
MAINTENANCE
CAUTION!
Structural modifications are subject to the manufacturer's written approval.
Æ
Only use original spare parts.
Æ
Contact the manufacturer, see
7.3.1 Die Clearance Adjustment
Check the die clearance at regular intervals: The clearance between the die and the punch must
Æ
continuously have the same width.
Æ
If required, adjust die clearance:
ɚ
Carefully lower the punch and stop just above the die.
ɚ
Release the two external adjustment screws of the die holder and
the knurled nut.
ɚ
Move the die holder to the left or right until you obtain a
continuous die clearance.
ɚ
Tighten the knurled nut.
ɚ
Tighten both adjustment screws.
7.4
TROUBLE-SHOOTING
CAUTION!
Æ
If you notice any indications of a fault, immediately switch OFF the machine and
disconnect it from the power supply, see
Do not operate the machine until the malfunction has been eliminated.
Æ
Æ
In case of any malfunctions or other discrepancies, contact your distributor, see
"8.1 Customer Service" on page
ɚ
Type designation and serial number (see type plate).
ɚ
All details of the normal operating conditions and the malfunction.
Æ
Repairs must always be carried out by authorized qualified personnel.
Æ
Repairs to the hydraulic system are subject to the manufacturer's written consent.
7.5
STORAGE
In case of long idle periods, store the machine at a place that meets the following requirements:
Unauthorized persons and children must not be able to access the machine.
ƒ
The storage place must be dust-protected, dry and designed for the weight of the machine.
ƒ
The machine must not be exposed to direct sunlight.
ƒ
The storage place must comply with the specified storage temperatures, see
ƒ
page
72.
Check the machine at regular intervals; corrosion protection measures and lubrication must be carried
ƒ
out as required.
© 1 1-2023, Modifications subject to change.
"8.1 Customer Service" on page
"3.4.3 Emergency Stop Button" on page
71. Please provide the following information:
71.
51.
"8.3 Technical Data" on
EN
69
Werbung
