Panasonic RX-DT610 Bedienungsanleitung Seite 15

PLAYING A DISC
M@ Program play
Up to 16 tracks can be programmed.
1. Press the skip/search button (</<< or >P/PP) to
specify the desired track.
Press the skip/search button repeatedly until the desired
track appears.
2. Press the memory/recall button.
The play sequence is first indicated and after 2 seconds,
the time of the whole play sequence is displayed.
Program indicator id
Total playing time for specified tracks
3. Repeat the steps 1—2 to be played in sequence.
(PGM)
"FULL" appears and flashes on the display when the
program memory is already full. This is to indicate that no
more additional track can be programmed.
4. Press the play/pause button.
Play starts in the programmed sequence.
®To stop the program play
Press the stop/clear button.
Play will stop automatically when all the programmed tracks
have been played through.
(Play will stop and the play program will be retained.)
eChecking what has been program
The tracks which have been programmed and the play
sequence can be checked for about 1 second when the
memory/recall button is pressed in the stop mode.
@ Clearing a program
@Clearing all the programmed tracks
(Cancelling the programmed play mode)
1. Press the memory/recall button in the stop mode.
The program indicator will start to flash on the display for
several seconds.
2. Press the stop/clear button while the program indicator is
flashing.
The program indicator goes out and the programming is
cleared.
ENGL
Clearing only the track programmed last
Press the stop/clear button in the stop mode.
Each time the button is pressed, the track programmed last
can be cleared in sequence.
Example: When tracks 3, 5 and 7 have been programmed,
the tracks will be cleared in the sequence of 7, 5 and 3 each
time the stop/clear button is pressed.
The programmed mode will be cancelled if you open the
disc holder.
Note:
It is not possible to clear only a track located in the
middle of the program (such as the third of 5 tracks).