Genius Nicer Dicer Smart Gebrauchsanleitung Seite 15

4.2 Using the blade inserts
Preparing food
Wash the food and remove stems, cores or pits, and peel if necessary. The food must be cut into small enough pieces to fit the
„
cutting area so that there is sufficient space between the food and the blade insert frame on all four sides.
Place the food with the cut side on the desired cutting surface.
„
CAUTION!
Risk of cutting injuries.
The blades are extremely sharp. Always hold parts by the plastic and do not touch the blades with your hands or other body parts under
any circumstances.
Only cut food by pressing down on the cutter top. Do not use your fingers to push food through the blade inserts under any circumstances.
ATTENTION!
If the cutter top does NOT descend fully in one stroke, then DO NOT apply any further force – this may damage the product. If the food has lodged
in the blades, remove it by turning over the blade insert (to the blunt side) and carefully pushing out the cuttings. Do the same to remove food
remnants from the blades and then use washing detergent and a brush.
The blade inserts may not be used to cut very hard food such as carrots, unpeeled squashes or similar. Cores and pits must be removed before
processing and the food may need to be peeled.
Before using, read the ' A ssembly' section. Only use the product if it has been assembled correctly.
batons/dices
Pos. 1
Instruction Manual
Insert the desired blade insert. The insert must audibly lock into place. Please ensure
that you do not touch the blades during use.
Always fit the blade insert so that the required cutting surface is in Position 1.
Pos. 2
+
GB
+
15