Tascam MA-BT240 Bedienungsanleitung Seite 17

Connecting with Bluetooth devices
Connect the included antenna to the front panel in order to
use Bluetooth.
Pairing
1.
Press the PAIRING button on the front panel for at least
two seconds.
The indicator to the side of the PAIRING button will
blink while pairing.
2.
Operate the Bluetooth device to be connected to this
unit.
o Refer to the operation manual of that Bluetooth
device for connection procedures.
o The indicator stays lit when connected to a Bluetooth
device.
3.
Operate the connected Bluetooth device and adjust
the volume.
o When a Bluetooth device is connected, playback
will be paused. After adjusting the Bluetooth device
volume, start playback.
o Bluetooth volume cannot be adjusted by itself with
this unit.
Adjust the volume on the Bluetooth device.
ATTENTION
Bluetooth is designed to send playback pause commands
using AVRCP basic commands.
However, this does not guarantee operation with all
devices.
When a Bluetooth device is connected,minimize
volume of the MASTER knobs and the the Bluetooth
device beforehand.
NOTE
When this unit is turned on, it will automatically try to
connect with the Bluetooth device to which it was previously
connected.
At this time, connection will automatically be canceled if
connection is not possible because that Bluetooth device is
not turned on or its Bluetooth function is turned off.
Disconnecting
The Bluetooth device that is currently connected can be
disconnected from the unit.
1.
Press the PAIRING button for at least two seconds.
2.
This ends the connection. The indicator will start blinking
and the unit will be ready to connect.
NOTE
o After about two minutes pass, the indicator will become
unlit and Bluetooth will turn off.
o Pressing the PAIRING button for at least two seconds
while the indicator is blinking will make it become unlit
and turn off Bluetooth.
TASCAM MA-BT240
17