CENTROPIX BUBBLE 2 Kurzanleitung Seite 15

Commissioning & Battery Charging
BUBBLE
Charging is required before using the
BUBBLE
the first time. The battery of the 2 is charged
inductively with the supplied charging station. To
do this, plug the USB-C connector into the char-
ging station and the USB connector into a suitable
USB socket of a power plug or to a device with
a supply current (e.g. computer). As soon as the
charging function is ready, a green LED in the char-
ging station lights up.
BUBBLE
Now place the 2 on the inductive charging
station. As soon as the charging function starts, the
BUBBLE
top LED on the back of the 2 lights up in
blue. If the blue LED flashes or is off, the battery is
fully charged. The full charging time is 3-4 hours.
BUBBLE
Now the 2 is charged and switched on.
07
Wearing the BUBBLE
2
BUBBLE
2 for The 2 is worn around the neck using the
leather collar supplied, with the light signal pointing
towards the body and the device resting directly on
the skin. Please be careful when pulling the leather
collar over your head to avoid damaging the collar
or the housing eyelet. Please note that damage to
the collar or the housing eyelet is not covered by
the warranty (liability for material defects).
There are three ways you can wear the
1st variant:
Attach the supplied carabiner through the eyelet on
the housing and then thread the collar through the
carabiner.
2nd variant
Alternatively, you can wear the
carabiner. To do this, take the collar, form a loop
and pass it through the housing eyelet from behind.
Then thread the two ends of the collar through the
loop and close the collar to secure it.
BUBBLE
2 :
3rd variant
BUBBLE
2 without a Of course, it is possible to replace the supplied
collar with another chain.
Important notes
BUBBLE
• The 2 must be taken off at night
and must not be worn.
BUBBLE
• The 2 logo must face forwards
when worn.
BUBBLE
• The 2 should be worn below the
sternum near the solar plexus.
• During the charging process, the B2 logo
must be facing upwards.
DE
EN
08