Dual 1216 Bedienungsanleitung Seite 9

Operating instructions
Pitch-control knob
Speed selector
Single-play spindle
Cartridge holder
Tonearm rest
Tonearm cue control height adjustment
Stylus force adjustment
Tonearm counterbalance
Anti-skating force adjustment
Cue control
Tonearm lock
Tonearm set-down adjustment
Record size selector
@O@OO@GOQSCOOHOZOHHO
Operating switch for automatic
start and stop
Chassis hold-down screw (for transport)
Tonearm lift and lock
Multiple-play spindle AW 3
Adapter for large-hole records
@@ee®
Multiple-play spindle AS 12 for large-hole
records (special accessory)
Single-play mode
Insert the short, single-play spindle (and,
for 45 rpm records, the center-hole adapter) ,
then place the desired record on the platter.
Fig. 6
Select the appropriate turntable speed (2),
set the record size selector @) to 7", 10" or
12". (17, 25 or 30 cm), depending on the
size of the record you want to play, and
unlock the tonearm (Fig. 7).
Now the unit is ready to play.
1. Automatic start
Move the operating switch to ''start"'.
Fig. 7
2. Automatic start with cue control
First move the cue control lever to position Y
and then the operating switch to ''start''. The
tonearm will descend very slowly and smoo-
thly onto the record.
3. Manual start with cue control
a) Move the cue control lever to position ©.
b) Move the tonearm by hand over the de-
sired spot on the record.
c) Gently move the lever back to &. (The
tonearm will descend.)
Fig. 9
Stack up to six records of the same size
and speed on the multiple-play spindle or
the special one for large-hole 45 rpm records.
When you move the operating switch to
start', the first record will drop and the
tonearm will lift, move to the record, then
descend. If you wish to reject a record
that is playing and move on to the next,
move the operating switch once again to
start'',
Note: Records that have been played can
be lifted back up the spindle for repeat
plays, or removed altogether. There is no
need to remove the spindle in either case,
* The 45 rpm record spindle AS 12 is avai-
lable from radio dealers as an accessory,
Fig. 8
4, Repeating a record
Move the operating switch to ''start''.
5. Interrupting play yv
¥ the tonearm descends on the record again ; '
A5 rpm disc supplied with your Dual on the
and a few grooves will be repeated. ; .
spindle platform after the record is on the
will shut off,
Note: After a single record has played, or after
the last record of a stack has played, the tone-
arm will return automatically to its rest and
the motor will! shut off. It is advisable then to
lock the tonearm on its rest (Fig. 7).
Multiple-play mode
Insert either the conventional changer (long)
spindle or the special one for large-hole,
45 rom records*, so that the pin slips into
the corresponding slot in the shaft. Lock
the spindle in place by pressing down and
turning to the right, until it stops.
Fig. 10