Dual 1216 Bedienungsanleitung Seite 11

In either case, turn the adjustment knob
to the number that corresponds to the stylus
force being used, Thus, if you have set the
stylus force to 1 gram, set the anti-skating
knob to ''1"" also (on the appropriate scale for
the type of stylus you have),
In case of stylus tips with radii other than
those given. above, you can select the correct
anti-skating setting from the following table.
Tracking Anti-skating compensation
Your automatic turntable is equipped with
a precise, jolt-free, silicone-damped tonearm
lifting device. With this cue-control, the tone-
arm can be placed over any spot on a
record, then lowered more gently than pos-
sible by hand, The rate of descent is inde-
pendent of temperature.
Its operating lever has two positions:
playing position ¥
lift position ¥, in which the tonearm is
lifted off the record surface. A light tap
the record in the V position can be ad-
in loud recorded passages. Too high a stylus
force can damage the stylus and record.
a IR
Pitch-control
Each of the three standard speeds (33 1/3,
45 and 78 rpm) can be varied about 6 %
ing — important when going from a dry record
to a moistened one.
For the two types of stylus in frequent use
today there are two different adjustment
scales:
|
anti- skating
Fig. 17
skating force is reduced by approximately
10 %. Therefore reduce the given calue of
skating compensation by about 10 %.
Cue-control
Fig. 19
Pitch is varied by using the pitch-control
knob @).
Adapting for different power frequency
The unit is adapted for use at a different
power-line frequency
by changing the motor
pulley
(A), which is secured to the motor
shaft by
a screw
and can be
reached by
removing the turntable.
Red: for (conical) styli with 15 micron radius
according to DIN 45 500
White: for (elliptical) styli with radii of 5 to 6
microns by 18 to 22 microns, Fig. 18