Supra SB2000 Gebrauchsanleitung Seite 6

the desired direction.
Turn the appliance on, by using one of the
speed selection buttons (3), (4) or (5)
Turn the thermostat control to the desired
temperature position (D).
FAN FUNCTION:
Select the fan position (3)
Check that the thermostat button is set to the
maximum (6).
HEATER FUNCTION:
Select the desired heating power (4) or (5)
Check that the thermostat control (D) is set to
the temperature required.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Select the minimum position (7) using the
thermostat control (D).
Stop the appliance, selecting position 0 (2) on
the selector control (E).
Unplug the appliance from the mains.
Put the cable back in the cable housing.
The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
Allow to cool
Clean the appliance.
CABLE COMPARTMENT
This appliance has a cable compartment
situated on its posterior (C).
CARRY HANDLE/S:
This appliance has a handle on the back to
make it easy and convenient to transport (B).
1-PORTADA-SUPRA SB2000.indb 6 1-PORTADA-SUPRA SB2000.indb 6
ANTI-TIPPING SAFETY DEVICE:
The appliance has an anti-tipping safety device
that turns it off if the working position is not the
correct one.
SAFETY THERMAL PROTECTOR:
The appliance has a safety device, which
protects the appliance from overheating.
When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
Remark: When the appliance is used as a
heater after long periods in storage or after
having been used solely as a fan a small
amount of smoke may be produced. This is
not important and is due to the heater burning
dust deposits which have accumulated on the
1/4/22 11:23 1/4/22 11:23