Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
28
Reversal of the display - Fig. 8
To activate this function, press UP
maintained even for the next time it will be switched on. To return to the initial state, repeat the operation all over again.
Setting the luminaire starting address.
On each luminaire, the starting address must be set for the control signal (addresses from 1 to 512).
The address can also be set with the luminaire switched off.
Setting the luminaire Fixture ID.
On each luminaire, the Fixture ID address must be set for an easy identification of the fixtures in an installation (ID from 1 to 255).
The Fixture ID address can be set with the luminaire switched off.
Functions of the buttons - Using the menu
USING THE MENU:
F
1) Press
once – "Main Menu" appears on the display.
B
2) Use the UP
and DOWN
• Setup (Setup Menu): To set the setting options.
• Option (Option Menu): To set the operating options
• Information (Information Menu): To read the counters, software version and other information.
• Manual Control (Manual control Menu): To trigger the test and manual control functions.
• Test (Test Menu): To check the proper functioning of effects
• Advanced (Advanced Menu): Access to the Advanced menu is recommended for a trained technical personnel.
F
3) Press
to display the first item in the selected menu.
B
4) Use the UP
and DOWN
Setting addresses and options with the luminaire disconnected.
The luminaire's DMX address, as well as other possible operating options, can also be set when the appliance is disconnected from the electricity supply.
F
All that is needed is to press
the display will switch off again after a wait time of 30 seconds.
- see ''DMX Channels'' and ''User Menu'' chart to set the correct fixture configuration.
M N XTYLOS
B
C
and DOWN
keys simultaneously while the display is in the rest mode. This status will be memorized and
F
Confirms the displayed value, or activates the displayed function, or enters the successive
menu.
C
Decreases the value displayed (with auto-repetitions) or passes to the next item in the menu.
DOWN
B
Increases the value displayed (with auto-repetitions) or passes to the previous item in a menu.
UP
D
Return to the top level
LEFT
Commute from units, tens, hundreds, in the Address , Fixture ID and Calibration menu.
RIGHT
C
keys to select the menu to be used:
C
keys to select the MENU items.
to momentarily activate the display and thus access the settings. Once the required operations have been carried out,
8
Werbung
