Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mains
5
Connecting to the mains supply - Fig. 5
6
DMX
Connecting to the control signal line (DMX) - Fig. 6
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity. Do not use
microphone cable or other cable with characteristics differing from those specified. The end connections must be made using XLR type 5 pin male/female
connectors. A terminating plug must be inserted into the last luminaire with a resistance of 120Ohm (minimum 1/4 W) between terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the connectors. The casing itself must be connected to the
shield braid and to pin 1 of the connectors.
7
Fixture ID
Dmx Address
Warning Message
Switching on the luminaire - Fig. 7
Ensure that the fixture is not remotely controlled, by disconnecting DMX cable during this operation, to prevent unwanted light emission.
Switch-on the fixture. The luminaire starts resetting the effects. At the same time, the following information scrolls on the display:
On conclusion of resetting in case of absence of the DMX signal, Pan and Tilt move to the "Home" position (Pan 128 bit - Tilt 128 bit). The control panel
(Fig. 8) has a display and buttons for the complete programming and management of the luminaire menu. The display can be in one of two conditions:
rest status and setting status. When it is in the rest status, the display shows the luminaire's DMX address and the Fixture ID address (if set).
During menu setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns to rest status.
It should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the
M N XTYLOS
3.3 Connecting the control signal line: DMX / Art-Net
3.4 Switching on the fixture and basic SetUp
1
2
Model
MINI XTYLOS
Firmware
xxx (Fixture ID)
Version X.X.X
DMX Address xxx
Date - Hour
7
DMX 512
5 PIN
5
1
SCREEN
4
2
3
SIGNAL
SIGNAL
Ethernet
System errors
E: .........................
W: .........................
F
key will be cancelled.
Continue
Werbung
