Werbung
"ables apna resrrinads
oulnce eee:
Radio Play Operations (for CQ-DP37LEE)
MONO
Indicator
Stereo Indicator
LOCAL
Indicator
Band Indicator
m e e t Sian O°
Preset Station
Indicator
/
| 1 To change tuner mode
| Press the PWR button on.
t
i 2 To select the desired band
Each time this button is pressed, the band will
change in the following order,
ie FM1 - FM2-+ FM3 > AM(LW/MW)
7
\_ Initial operation is preset for FM1 band.
3 Manual tuning
| By pressing the " \ V TUNE/SEEK" or "TUNE/SEEK
|
/\" button, you can tune the frequency downward or
(upward,
f
4 Seek tuning
Press the "WV TUNE/SEEK"
or "TUNE/SEEK A "
button for more than a haff second, seek tuning will
operate and stop automatically on the next strong
Station. 'Continue this operation unti! you find the
desired station.
button to change CD mode.
"Note: While the disc is inserted, press the mode —
5 To tune in a preset station
Press the preset buttons to recall! the previous preset
_ Stations,
stereo broadcasts (MONO Button)
Press the MONO button to switch monaural recep-
tion in case much interference is present in an FM
weak FM broadcasts.
"MONO"
indicator will be
illuminated.
7 Switch from DX to LOC
Normally, searching
stops even at a weak
wave
| station. To stop searching at a strong wave station
only, press this button.
"LOCAL" indicator will be ill:minated.
6 To reduce interference during FM
stereo signal or to improve the 'listening quality of
Radio Play Operations (conta) (for CQ-DP37LEE)
Preset Station Setting
Up to 24 stations can be preset in the station memory as follows;
|
|
|
|
(EMT
FM2
FM3
|
is ee
6 stations
[AM ILW/MW) |
6 stations
| 6-stations J
f 6 stations
1 To select the desired band
Press this button to select FMi, FM2, FM3 or AM(LW/MW)
mode.
2 To tune in the station you want to listen to.
You can tune in a desired station either by manual tuning or seek tuning.
3 Auto preset - Preset scan
Auto preset:
Hold this button for at least 2 seconds.
Up to 6 strongest stations along the frequency
band will
automatically preset into six preset buttons (1 - 6). Scan will immediately follow from preset number 1 as
soon as the auto preset is completed. Press the "P-SET" again when reaching the desired station. This
can be done on any band.
Preset scan:
Press this button to scan each preset stations for 5 seconds. When reaching the station, simply press
the "P-SET" again to cancel the preset scanning.
Note: FM1, FM2 and FM3 cannot be scanned continuously.
| circuit in which the band is playing.
4 To memorize the station in the memory
Press one of the preset buttons for several seconds. Release when the radio frequency indicator blinks
once. The memory has been set.
Preset other stations on other bands in the same manner.
Note: If any of these
station selectors
is accidentally
pressed
and held for several
seconds,
the
previously preset station will be erased; instead, a different station will be registered into that memory
33 1V/9D3ALEd
Werbung
