Werbung
Speaker Connections
CAUTION:
1. Use ungrounded speakers only.
2. The speakers to be used with this unit should be able to handle more than 20W of audio power. If
an optional amplifier is used, the speakers should be abie to handie the maximum output power of
the amplifier. Use of speakers with small input ratings can cause damage to the speakers.
. The speaker impedance should be 4 - 8 ohms. If the impedance is too large or too small, it affects
the output and may cause damage to the speakers or this unit.
. Do not use 3-wire type speaker system having a common earth lead. Never connect the speaker cord
to the body of the car. This unit uses the BTCL
circuit, so each speaker should be connected
separately using parallel vinyl insulated cords.
. The speaker cords and the power amplifier unit should be kept away (about 30cm apart) from the
antenna and antenna extension cord.
. Follow the connection diagram below carefully. Failure to do so may cause damage to both unit and
speakers.
®@ Unit will be damaged if speakers (Front, Rear) are not connected property.
RIGHT
WRONG
White
White w/
Black Stipe
Gray w,
Black ume
Chassis
®@ Do not connect more than one speaker to one set of speaker leads.
RIGHT
WRONG
a |
White w/
Black Stripe
Gray w/
Black Stipe
Fuse
Be sure to use a fuse of the specified rating (815A, 10A) when replacing a blown fuse. Fuses with higher
Capacity ratings, use of any substitute, or connection without a fuse may result in a fire hazard or damage
to the unit.
Maintenance
To clean the exterior of this unit, use a soft cloth to wipe the surface.
Do not use benzine, thinner, or any
other type of solvents.
ee
ae ee NS EEN Ne Ee
Electrical Connection
Caution:
@ To prevent damage to the unit be sure to follow the connection diagram below.
@ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundie all
cables and keep cable terminals free from touching any metal parts.
CQ-DP37VEG
ANTENNA
ANTENNA RECEPTACLE
Noise filter
GROUND LEAD
Connect to a well grounded metallic
Black
part of your car.
wes
8
BATTERY
LEAD (To Battery of Car)
Connect to the "BAT" terminal on
the fuse block of the car.
The power should be supplied con-
tinuously to the yellow leads regard-
less of the on/off position
of the
ignition key.
Yellow
:
a
POWER LEAD
Connect to the "radio" power line of
White
aa
the car or to the "IGN" or "ACC"
(ih)
\ terminal of the fuse block.
)
:
FUSE (3.154)
PREAMP OUT CONNECTOR
{ TELEPHONE MUTE LEAD
\
Rear
{To car telephone mute iine)
TELEPHONE MUTE
The
telephone
mute
lead,
if con-
nected
to the car telephone mute
Orange
Z|
line, will activate the muting circuit
and
the sound
from the speakers
cannot
be
heard
while
the tele-
phone Conversation is in progress.
Note:
This telephone
mute
lead
is
for connection
only
to the
radio
mute line. Be sure to ascertain this
Dark Blue
because it will not work with other
=
type of output system.
MOTOR ANTENNA RELAY
CONTROL LEAD
Gray w/Biack Stripe
Violet w/Black Stripe
_JS
(To Motor Antenna) (Max. 500mA)
ZS
This lead is not intended for use
White w/Black |! White
Gray
Green w/Black ||] Green
Violet
with
switch
actuated
power
Stripe
Stripe
antenna.
Caution:
oO
&
Oo
&
oO
wW
O
WwW
To
prevent
the
unused
speaker
output cords from coming into con-
tact
with
the
ground,
the
cords
should be put on with caps attached
to the speaker
cords
of the front
side.
LEFT SPEAKER
RIGHT
SPEAKER
LEFT
SPEAKER
RIGHT
SPEAKER
(FRONT)
(FRONT)
(REAR)
(REAR)
33a1V/DSA
Werbung
