Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installations and Connections
Caution:
ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.
The following installation should be made by qualified service personnel or system installers.
■ Preparations
Important:
• Procure 4 mounting screws according to the material of the installation area. In this case,
wood screws and nails should not be used.
Recommended tightening torque is as follows:
M4: 1.6 N·m {16 kgf·cm}
• Required pull-out capacity of a single screw/bolt is 196 N {20 kgf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area
shall be sufficiently reinforced.
• The protection sheet attached to the dome cover should be peeled off after installation.
● Direct mounting
If the camera is directly mounted on a
wall/ceiling, align the camera mounting posi-
tion with the position of the hole through
which the cables run and make the hole.
If no hole is made through a wall/ceiling and
open wiring along a wall/ceiling is used,
process the cover so that the cables can be
run through the side of the cover.
Processed section of the side
surface of the cover
All manuals and user guides at all-guides.com
● Using a two-gang junction box
When using a two-gang junction box (4" x
4"), procure one locally that meets the
dimensions in the figure.
Next locally procure four camera-mounting
screws suitable for the installation surface
and structure of the wall/ceiling or two-gang
junction box.
11
Werbung
