Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ed speed setting". Ultimately, the best way to de-
termine the correct speed for work on any material
is to practice on a piece of scrap.
RECOMMENDED SPEED SETTING
Grinding stones (Fig. D)
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Felt wheels and tip (Fig. E)
The felt wheels or tip should be screwed on the
mandrel.
Material
Steel
Aluminium, brass
Plastic
Sanding bands and disc (sanding disc not included)
(Fig. F)
Material
Wood
Steel
Aluminium, brass
Plastic
Bristel brush (Fig. G)
Material
Stone, shell
Aluminium, brass
High speed cutter, Diamond wheel point and Drill
(Fig. H)
Material
Stone, shell
Steel
Aluminium, brass
Plastic
WWW.VONROC.COM
Abrasive disc (Disc not included) (Fig. I)
Speed setting
5. MAINTENANCE
1-2
2-3
2
1-2
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
Speed setting
solvents such as petrol, alcohol, ammonia water,
2-3
etc. These solvents may damage the plastic parts.
Please clean the tool immediately after use.
2
2-3
ENVIRONMENT
Speed setting
3
Only for EC countries
Do not dispose of power tools into domestic waste.
1-2
According to the European Guideline 2012/19/
2
EU for Waste Electrical and Electronic Equipment
1-2
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
Speed setting
WARRANTY
2
2
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
Speed setting
failure during this period due to defective material
3
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
2
guarantee:
3
• Repairs and or alterations have been made
1-2
or attempted to the machine by unauthorized
service centers;
Material
Steel
Aluminium, brass
Plastic
Make sure that the machine is not live when
carrying out maintenance work on the motor.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that purpose.
EN
Speed setting
2-3
2
1-2
11
Werbung
