Husqvarna 325iLK Bedienungsanweisung Seite 12

Introduction
WARNING:
safety chapter before you use the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 25)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
Work position
• Hold the product with 2 hands.
• Hold the product on the right side of your body.
• Keep the cutting attachment below waist level.
• Keep body parts away from the hot surfaces.
• Keep body parts away from the cutting attachment.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
12
Operation
Read and understand the
Only use Husqvarna
If the battery does not
Maintenance
Before you do any
• Make sure that all covers, guards, handles
and accessories are correctly attached and not
damaged.
To start the product
1. Push and hold the start button until the green LED
comes on. (Fig. 26)
2. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. Withe the mode button
the operator can limit the maximum speed. The mode
button has 3 speed levels. A lower level increases the
time of operation for the product. The mode button has
3 speed levels. A lower level increases the time of
operation for the product. Use level 1 and level 2 if the
operation does not require full speed/full power. If the
operation condition requires full speed/full power, use
level 3. Do not use a higher level than necessary for the
operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on. (Fig. 27)
2. Push the Mode button again to choose the next
speed level.
Automatic shutdown function
The product is equipped with a shutdown function that
deactivates the product if it is not used.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the stop button. (Fig. 28)
3. Push the release buttons on the battery and pull the
battery out. (Fig. 29)
Maintenance schedule
WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
Remove the battery before
1318 - 009 - 27.09.2023