Ark Vision Systems ArkCam Basic+ Produktanleitung Seite 24

Recommendation Camera Startup
Configuration ArkCam Basic+
The network configuration of the cameras is then done one by one using a PC connected to the switch.
The PC's network card is set to the camera's default destination IP (192.168.0.150).
One camera at a time is then connected to the switch and configured.
Ex. camera 1:
1) Access camera 1 via web browser to the preset default address 192.168.0.76.
2) Changing the camera IP address on the Network subpage to another address in the subnet (not equal to
192.168.0.76 and 192.168.0.150), e.g. 192.168.0.77 à causes automatic reboot and display of the new
address in the address bar of the browser
3) Set camera stream on Video Settings subpage as H264 RTP stream
H.264
Stream Type: RTP/RTSP
▪
RTP Destination IP: 192.168.0.151 (corresponding to the IP address of the desired destination moni-
▪
tor, here: Monitor 1)
RTP Port: 5004 à Change to 5006 (Attention: Only even ports allowed!)
▪
GOP: 30
▪
Bitrate Mode: Variable
▪
Bitrate: 15 Mbit
▪
MJPEG
Stream Type: RTSP
▪
Other settings unchanged
▪
When one camera is configured, it can remain connected to the switch and the next one can be plugged in.
For cameras 2 - 4 then repeat the above steps and configure the corresponding IP addresses and H264 desti-
nation ports according to the table.
Hint:
If a camera is to be displayed on multiple monitors, the destination IP must be set to the broadcast address of
the subnet (e.g. 192.168.0.255)!