Werbung
Verfügbare Sprachen
Verfügbare Sprachen
in compliance with current standards
en
and instructions given by the manufac-
it
turer in this instruction manual. Work
involving access to dangerous areas
de
(maintenance, repairs, etc.) must be
es
carried out by the authorised technical
fr
support centre to prevent any risks.
••2.9.
IMPORTANT: The heater does
nl
not have gas regulators or pipes to
pt
connect it to the mains. Therefore,
you will need to contact an authorised
da
technician for the installation.
fi
••2.10.
IMPORTANT: The heater is
no
supplied with a specific gas setting.
Any kind of change and adjustment
sv
must be performed by an authorised
pl
technician or by the authorised tech-
ru
nical support centre. IF ANY CHANG-
ES AND ADJUSTMENTS ARE PER-
cs
FORMED, YOU WILL NEED TO FILL
hu
IN THE NEUTRAL DATA PLATE SUP-
PLIED WITH THE HEATER.
sl
••2.11.
IMPORTANT: The settings of
tr
the supply gas pressure values must
hr
be checked by an authorised techni-
cian.
lt
••2.12.
IMPORTANT: The heater must
lv
be installed exclusively in accordance
et
with the instructions contained in this
instruction manual to prevent any po-
ro
tential fires.
sk
••2.13.
IMPORTANT: Do not use to
bg
heat homes or residential buildings;
for use in public buildings, refer to na-
uk
tional regulations.
bs
••2.14.For correct use of the heater
and for preservation of the fuel, follow
el
all local regulations and the Standard
zh
in force.
••2.15.If the heater is installed in-
doors, it needs an adequate supply of
fresh air. It must therefore be used in
rooms with a guaranteed and continu-
ous supply of fresh air. National Stan-
dards in force are valid for installation
and assessment of the supply of fresh
air, including the Technical Standards
and the provisions regarding accident-
prevention and the prevention of fires.
••2.16.The appliance must only be
used as a hot air heater (heating mode)
or fan (ventilation mode). Follow these
instructions scrupulously.
••2.17.Only use fuel, gas pressure val-
ues, voltage and electrical frequency
clearly specified in the data plate ap-
plied on the heater.
••2.18.Make sure the heater is only
connected to suitable mains with a dif-
ferential switch and suitable earthing.
••2.19.It is prohibited to use the heater
in basements and rooms below ground
level.
••2.20.The heater must not be used in
places where explosive dust, fumes,
gases, fuels, solvents, paint, etc. are
present.
••2.21.Whenever the heater is used
near tarpaulins, awnings or similar
covering materials, additional protec-
tion is recommended, such as fire-
proofing. Make sure the hot parts of
the generator are kept at a suitable dis-
tance from inflammable materials (fab-
ric, paper, wood, etc.) or thermolabile
materials (including the power supply
cable). In any case, the distance should
never be less than 3 m.
••2.22.The air vent (lower side) and/
or the air outlet vent (front side) must
not be totally or partially obstructed
for any reason You can use air duct-
ing from or to the heater. The only au-
thorised ducting is the one supplied as
optional items by the manufacturer.
••2.23.If the heater does not switch
on or switch-on is anomalous, please
see the relative section (Paragraph on
"Troubleshooting").
••2.24.The heater must never be
moved, handled or subjected to any
Werbung
