Sharp XE-A301 Bedienungsanleitung Seite 11

4
Installing paper rolls
Precaution: The paper cutter is mounted on the printer (receipt side). Take caution when
installing paper rolls.
The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal
paper rolls) provided with the register.
Install the paper rolls according to the procedure shown below with the power cord connected and the mode
switch set to the PGM position:
How to cut a paper roll and set it in the paper roll cradle:
Correct
1.
Cut off approximately one revolution of each paper roll. Make sure each paper end is cut as illustrated
above.
2.
Set a paper roll in the paper roll cradle of the receipt side as illustrated above.
3.
Insert the end of the paper roll into the paper chute until it is caught by
the printer auto-feed and comes out of the top of the printer. If the
printer does not catch the paper, feed the paper while pressing the
key.
4.
Cut off excess paper with the paper cutter.
5.
Set a paper roll in the paper roll cradle of the journal side.
6.
Insert the end of the paper into the paper chute of the printer until it is caught by the printer auto-feed and
comes out of the top of the printer. If the printer does not catch the paper, feed the paper while pressing the
}
key.
7.
Insert the end of the paper into the slit in the take-up spool. (Press the
}
key to feed more paper if required.)
8.
Wind the paper two or three turns around the spool shaft.
9.
Set the spool on the bearing, and press the
slack in the paper.
10.
Replace the printer cover.
Incorrect
}
key to take up excess
To the printer
Correct Incorrect
{
To the printer
9