Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Direction control
WARNING
NEVER change the direction of rotation while the tool is running. This may cause
permanent damage to the tool.
●
The direction of rotation can be set using the Forward/Reverse Switch (6).
●
For anti-clockwise rotation, push the switch to the right.
●
For clockwise rotation, push the switch to the left.
Note
When the Forward/Reverse Switch is in the central position, the drill is locked and
cannot be switched on. Use this setting as a safety feature to prevent the drill from
being switched on accidentally.
Note
This cordless drill is equipped with a torque control clutch allowing the machine to be
set to the correct torque for the individual application.
●
The clutch settings are indicated by the symbols on the Torque Selector (3)
●
Rotate the Torque Selector to select the desired setting: the higher the number
displayed on the torque ring, the higher the torque produced by the too.
Gear selection
●
Select gear 1 on the Gear Switch (4) for the higher torque. A lower speed gear is
generally more suitable for driving screws and fasteners
●
Select gear 2 on the Gear Switch for the lower torque. A higher speed gear is for
drilling and must not be used for driving screws and fasteners.
Note
ALWAYS read the documentation provided with drill bits and accessories for the
recommended or maximum speed setting and use the most appropriate gear. See
'Specification' for the maximum no load speed of each gear.
WARNING
ALWAYS wear adequate personal protection equipment when setting up and operating
this machine.
Operation
Torque control
Switching on/off
- 12 -
Werbung
