Werbung
Verfügbare Sprachen
Verfügbare Sprachen
air vents. Failure to follow these instructions may cause overheating or fire.
●
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
WARNING
DO NOT attempt to recharge non-rechargeable batteries.
Removing a battery
Remove the Battery from the tool by pressing the Battery Release, then slide the
Battery out of the Battery Slot.
WARNING
DO NOT try to remove the Battery without pressing the Battery Release button. The
tool or Battery could be damaged.
Fitting a battery
1.
Fit a battery by sliding it on to the Battery Slot of the tool until it clicks and locks
into position.
Note
Make sure the Battery and tool are lined up correctly. If the Battery does not slide into
the tool easily, do not force it. Instead, slide the Battery out of the tool again, check
the top of Battery and the tool battery slot are clean and undamaged and that the
contacts are not bent.
Setting up the battery charger
1.
If fitted, remove any Battery from the Battery Charger.
2.
Insert the Battery Charger mains plug into a suitable mains socket.
Note
The RED LED on the Charger base will on to indicate that the charger is ready to
charge the battery.
WARNING
Use this charger ONLY to charge the supplied battery or additional purchased
batteries that are specifically designed for this tool.
WARNING
The charger is designed for indoor use only, and MUST NOT be used in damp or wet
conditions.
Before Use
- 09 -
Werbung
