SOMFY LT50 Anleitung Seite 4

EN
2.1.3. Drive/tube assembly
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
2) The drive wheel must be locked in place to prevent it
moving along the roller tube:
•
drive wheel using 4 x Ø 5 mm self-tapping screws,
or by using 4 x Ø 4.8 mm steel pop rivets placed 5
mm to 15 mm from the outer rim of the drive wheel,
regardless of the roller tube.
The screws or pop rivets must only be attached to
the drive wheel and not to the drive.
• Alternatively, a drive wheel stop can be used for tubes which are not smooth.
2.1.4. Installing the drive/tube assembly
and onto the drive bracket g:
Ensure that the drive/tube assembly is secured onto
the end bracket. This operation prevents the drive/
tube assembly from coming out of the end bracket
mounting when the roller blind reaches the lower end
limit position.
place.
2.2. WIRING
Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
The cable on the LT50 can be removed. If it is damaged, replace it with an identical cable.
If the motor is used outdoors and if the power supply cable is of the H05VVF type, then run
the cable in a UV-resistant conduit, e.g. trunking.
Leave the motorisation power supply cable accessible: it must be possible to replace it
easily.
Turn off the power supply.
-
Connect the motorisation according to the information in the table below:
-
Neutral
230V -50 Hz Blue
220V -60 Hz
120V -60 Hz
White
100V -
50/60Hz
4
Live Earth
Brown Yellow/
Green
Black Green
Copyright © 2016-2020 Somfy Activités SA, Société Anonyme. All rights reserved.
1)
2)
f
1)
g
2)
h in
h
1
2
3
3 x 1,5 mm
15 mm
5 mm
L1
20 mm
f
2
2
3 x 0.75 mm