Werbung
Verfügbare Sprachen
Verfügbare Sprachen
and individually adjusted by doing so. To do this, release the individual LED lamp from the
slot (3) by pulling lightly on the upper edge. It disengages on doing so.
Unplug the power cord from the mains socket after operation. Engage the individual LED
lamps (4) again by pressing them lightly into the slots (3), you will hear a click. Then roll
the power cord back onto the cord winder (5).
6. Maintenance
Your product requires very little in terms of maintenance and care. Store the work light in
a dry and frost-free place; the ambient temperature should not exceed 40 °C.
It is not possible to replace the LED bulb. If a fault occurs, please contact your STORCH
sales team member.
7. Troubleshooting
The following measures must be performed by the manufacturer, a service organisation,
or another qualified person:
• Replacement of the power cord.
Symptom
The work light is not working.
The work light is becoming hot.
48
Remedy
Make sure that the mains plug is correctly
plugged in and that there is voltage at the
mains socket.
This is normal in case of intensive use,
however, to avoid damage, it makes sense
to allow the product to cool down regularly.
Translation of the original instruction
Werbung
