Herunterladen Diese Seite drucken

Le Chai LM78 Bedienungsanleitung Seite 133

Errichtet weinkeller
Vorschau ausblenden Andere Handbücher für LM78:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

From time to time, dust off the condenser under the device; accumulated dust may reduce the efficiency
of your wine cabinet.
In the event of a prolonged absence, empty and clean out the device; maintain the door slightly open
during the period of non-use.
REPLACING THE ILLUMINATING LAMP
The device uses light emitting diodes (LEDs). This type of diode cannot be changed by the user. The life
cycle of the LEDs is long enough so that they do not need to be changed. If however, in spite of the
care taken by the manufacturer, the LEDs do fail, please contact your Customer Care Service for any
repair.
TROUBLESHOOTING
You can resolve many of the problems that may arise without having to call Customer Care Service.
Please try the suggestions below.
No operation
Not cold enough
No interior light
No display on the LCD screen
There appears to be a loud noise
The door does not close properly
The light (LED) does not come on
LED display error
The fans are not working
PROBLEM
POSSIBLE CAUSE
• Check your installation's power supply
• Check your circuit breaker
• A fuse has blown
• Check the setting temperature
Ambient temperature requires readjustment of
the temperatures
• The door is open too often
• The door is not closed properly
• The door seal is not air-tight
• There is not enough space around the
device
• Contact your Customer Care Service
• Check the device levelling
• Verify that a piece of paper or part of the
packaging has not remained stuck in the
device.
• Check the device levelling
• The seal is in poor repair
• The feet have "moved"
• The control panel is not working
• Printed circuit problem
• Mains plug problem
• Contact your Customer Care Service
• Poor display
• The temperature value is not shown
• Contact your Customer Care Service
• Control Panel to be replaced by your
Customer Care Service
EN-133

Werbung

loading