Le Chai LM78 Bedienungsanleitung Seite 123

The cooling system
According to specialists, the ideal temperature for wine storage is around 12 ° C, in the range of 10 ° to
14 ° C. Do not confuse with the operating temperature, which varies depending on the specificity of
each type of wine from 5 to 18 ° C.
It is especially important to avoid sudden temperature changes. Designed by specialists, for wine lovers,
this device, unlike the single refrigerator, electronically ensures constant average temperature
control.
The anti-vibration system:
The compressor is equipped with special shock (silent-blocks) and the inner tank is isolated from the
body by a thick layer of polyurethane foam. These features can prevent the transmission of
vibrations to the wines.
The humidification system:
This device is equipped with a tray (depending on model) which maintains the correct level of humidity. If
the humidity is too low, fill the tank level to ¾ of its capacity. Check the water level time to time and
add water if necessary. Make sure the tank always contains water.
The tray is placed on the shelf under the fan at the bottom to provide a minimum humidity.
Be careful to control the water level if you store your wines for a long time and you do not dedicate the
unit to their implementation at operating temperature only (with rapid rotations of your bottles).
The UV system:
The light accelerates aging of your wines. In full doors cellars, the wines are naturally immune subject of
course limited openings). This model glass door was subject of a particular treatment, which filters
harmful ultraviolet rays; the wines are perfectly safe.
Defrost:
This product does not produce frost (No-Frost). There is no frost or ice; so, no operation is required to
remove it.
Shelves
To prevent damage to the door seal, make
sure the door is open before pulling the
shelves to install or remove the bottles.
For easier access to the contents of shelves
you need to slide the shelf outward about
1/3 however they are designed with a
stop on each side to prevent the bottles
from falling.
To remove or position the shelves, move the
shelf to the position where the notch of
the wooden shelf is exactly under the
plastic rack stop and then lift it up and
out.
DOOR OPENING MECHANISM (PUSH-AND-OPEN DOOR FUNCTION) (on some models)
The push-and-open door function (if your model supplied with it) is activated when the unit is powered.
To open the door, push the door slightly inwards on the top left position for the right hinge model (the
top right position for the left hinge model) and then release it again. The unit will beep once to
confirm the action. The door will be opened approx.2~7cm by the push rod. Then the door can be
fully open manually. The push rod will return to its initial position after 3 seconds automatically. And
the unit will beep once again and it is ready for next opening action.
NOTE:
- The door will close again automatically after approx. 3 seconds if it has not been fully opened
manually for models with automatic door closing function.
EN-123